Jaton Game Card II Download Treibers

Installation instructions
-------------------------
Windows 95
----------

To prepare for installation of the drivers

1 Start Microsoft Windows 95.

2 Click the Start button, point to Settings, and click Control Panel.

3 Double-click Display, and click the Settings tab.

4 Click Advanced Properties, click the Adapter tab, then click Change.

5 Select Show all devices.

6 Select the Standard display types from the Manufacturers list.

7 Select Standard PCI Graphics Adapter (VGA) from the list, then select OK.

8 Click Apply, click OK, then click Apply.

9 Click Yes when Windows asks if you wish to restart the computer.

To install the drivers

1 Click the Start button, point to Settings, and click Control Panel.

2 Double-click Display, and click the Settings tab.

3 Click Advanced Properties, click the Adapter tab, then click Change.

4 Select Have Disk, then select or type the path to the driver files, then click
OK.

Windows should find files for your NVIDIA graphics chip. If Windows cannot
find the files, check that the path name for the diskette is correct and
that the correct diskette is inserted in it.

5 If Windows found the files, select OK.

Windows copies the files to the hard disk.

6 Click Apply, click OK, then click Apply.

7 Click Yes when Windows asks if you wish to restart the computer.


Windows 98
----------

To prepare for installation of the drivers

1 Start Microsoft Windows 98.

2 Click the Start button, point to Settings, and click Control Panel.

3 Double-click Display, and click the Settings tab.

4 Click Advanced, click the Adapter tab, then click Change.

5 Click Next, click Display a list of all the drivers in a specific location, so
you can select the driver you want, then click Next.

6 Select Show all Hardware button, then select the Standard display types from
the Manufacturers list.

7 Select Standard PCI Graphics Adapter (VGA) from the list, then select Next.

Requirements
------------

- Windows NT 4.0 or later
- PC with a Pentium II, Pentium Pro, Pentium or similar processor
- One free PCI slot (or two free PCI slots for SLI)
Installation
------------

The setup program must be run under Windows NT to install the Windows
NT drivers and 3Dfx device services. The account used during install
must have administrator permissions.

1) Run the self-extracting executable to begin setup.
2) Follow the on screen prompts.
3) After installation you may need to reboot the system.
Troubleshooting Voodoo2
-------------------------------

####

Q: I have an S3 968/868 video card, why does my system lock
up when I run a Glide or Direct3D title.

A: S3 968 and 868 chipsets may misreport the mapped memory used.
There is a chance that your Voodoo2 card will be assigned by
Plug and Play a memory range that is used by the S3 card, but
not reported. The Voodoo2 card can be relocated by:

Windows NT Users: An NT service called NTREMAP is
installed when Glide is added to an NT system.
NTREMAP can change the memory address of a Voodoo2
board and prevent a conflict with an S3 card.

To use NTREMAP, add the following registry values to:
\HKLM\Software\3Dfx Interactive\NTRemap

Value Name Type Value
---------- ---- -----
EnableNTRemap DWORD 1 (HEX)
ForceAddress DWORD 12000000 (HEX)

The Force Address setting will vary, in this example
0x12000000 is used. This is normally free on most
systems.

NOTE: If you use an address that over-writes another
device, Windows NT may not boot. If such a problem
occurs, power off the system and remove your Voodoo2.
Alter the registry to use a different memory range
(or remove the ForceAddress setting). Then Reinstall
the Voodoo2 card into your system.