Aten IC-428P Download Treibers und Manuell

Welcome to Serial Interface / PCI Card This latest version contains corrections to the last version and additions to the next version. You will find them listed below. Version History: V6.0.0 - Initial Release

?? INSTALLATION GUIDE FOR PCI SERIAL PORTS.......................................3
?? INSTALLATION GUIDE FOR PCI PARALLEL PORTS................................8

Welcome to Serial Interface / PCI Card This latest version contains corrections to the last version and additions to the next version. You will find them listed below. Version History: V6.0.0 - Initial Release

?? INSTALLATION GUIDE FOR PCI SERIAL PORTS.......................................3
?? INSTALLATION GUIDE FOR PCI PARALLEL PORTS................................8

Features
?? Fully compliable with PCI Specification Version 2.2 standard
?? Supports both 64-bit & 32-bit PCI Bus and 3.3V &5V connector keys
?? High speed serial ports support baud rates up to 921.6Kbps
?? 128K FIFO memory can reduce CPU loading and interrupting and will improve
system performance dramatically.
?? RS-422/485 Auto Identify and Switch technology makes it more convenient to
manage devices without jumpers or switch settings.
?? Auto RTS Signal Control technology can identify the status of the data transceiver
or receiver and send an RTS signal automatically, instead of using software to
control the transmitter.
?? Embedded surge protection (600W) for all signals.
?? High speed 16C650 compatible communication controller with SUN1889 single
chip hardware flow control guarantees no data loss.
?? Plug and Play, I/O addresses and IRQs assigned by BIOS.
?? Supports Microsoft Windows 3.x, 9x, NT, 2000, XP, 2003, DOS, and Linux.

Normally any serial and parallel I/O ports can be supported by BIOS call
services in DOS environment. However there are only support 4 serial ports
(3F8h,2F8h,3E8h,,2E8h) and 3 parallel ports (3BCh/378h/278h) are supported
by BIOS/DOS.

If the user has more than one PCI-Card in the Slots, the dos driver
pcidos.exe remap the first ports, that found on the PCI-Slots. If the user wish
to remap ports of another PCI-Card, the Cards in the slots must
changed.

In case the PCI serial and parallel ports are different from the
above configurations (e.g. I/O address or more than 4 serial ports / 3
parallel ports), they are not supported by BIOS/DOS directly. However some
applications (e.g. "PComm Plus" could support 8 serial ports and each I/O
address is settable) have their own driver, thus PCI cards could
work correctly.

The following procedures will instruct you to install PCI serial
and parallel port device driver for DOS and Windows 3.1

Serial/Parallel PCI Card Driver Version 6.000, 2004/02/26

Supported Operating Systems:
Windows 2000 (x86)
Windows XP (x86)
Windows Server 2003 (x86)

To install or update the driver, run setup.exe.

Serial/Parallel PCI Card Driver Version 6.001, 2005/02/15

Supported Operating Systems:
Windows 2000 (x86)
Windows XP (x86)
Windows Server 2003 (x86)

To install or update the driver, run setup.exe.