Aztech SC 128-3D Download Drivers

S3Mixer Version 3.4

[How to use S3Mixer]
1. S3MIXER.EXE can be located under \Windows directory.
2. Make sure s3legacy (real mode DOS driver) is installed.
3. Type s3mixer /? for help.
4. Type s3mixer to bring up the GUI for changing settings.
Settings will be saved to S3Init.ini file if you choose Save.
5. Type s3mixer /x to run S3Mixer as command line, it reads
the settings from S3Init.ini and will not bring up GUI.
6. Type s3mixer /MA:12,12 to set Master volume in command line.
You can type s3mixer /? for other command line switches.

[Advanced Users]
1. Use debug to change CM00_0 to SoundBlaster mode or Native Mode.
2. Bring up S3mixer GUI. It will display the pages according
to the mode.
3. Settings for SB mode will save to [Legacy] section in s3init.ini
file. Settings for Native mode will save to [Native] section
in s3init.ini file.

[Note]
1. Command Line switch(RE:0/1) in S3MIXER.EXE, the reverb selection
is not supported.

SC128-3D PCI Audio

Version 1.21
============
Installation of Audio Driver for Windows NT 4.00

1. Unload any Audio Driver(s) in your systems (if applicable)

a) Under Windows NT's control panel, select "Multimedia" icon and open
the "Devices" folder. Click on "Audio Devices" and select <Remove>
to unload any "Audio driver(s)". Restart Windows NT if you do not
have any other Audio Device/MPU/Joystick drivers loaded. Else,
b) Under Windows NT's control panel, select "Multimedia" icon and open
the "Devices" folder. Click on "MIDI Devices and Instruments" and
select <Remove> to unload any MPU401 Drivers, then restart Windows NT.

2. Install the Windows NT Audio Driver as follow:

a) Select Run from the Start Menu and enter: D:\NT40\SETUP.EXE {assuming
your CD-ROM is your D:drive}.
b) Follows the instruction on the screen to install the drivers.


Note: To install 128-voice under Windows NT 4.00, please refer to Section 6
the README.DOC in the Root directory of this CD.