Boeder PC Chat Cam USB Download Drivers

1. Introduction:
boeder PC Chat Camera is a Windows Plug and Play product. The driver can be
easily installed through plug and play procedure. This section
consists of two parts:
A. First-time Installation: for first-time installing a Divio PC
Camera on your system.
B. Updating Driver: If a previous version of the driver is installed
on your system, please follow this part of instructions.

The driver configuration is defined in the the pcam2.inf file. The
default settings for the CCD type and the CDS type are Sharp CCD and
CDS. A user must change the default settings to match his/her
hardware configuration before installing the software. Use an Editor
to change the settings according to the instructions provided inside
the pcam2.inf file.

This document is eligible for Divio PC Camera driver B3.00 and all
later versions.


2. Driver Installation Procedure

Note: Before you do the installation please change pcam2.inf to set
the correct "CCDType" and "CDSType" values and the correct
R/G/B values (RedHue_Office, GreenHue_Office, BlueHue_Office,
RedHue_Home, GreenHue_Home, and BlueHue_Home)to the
corresponding CCD.

For CCDType: 0 - Sharp CCD
1 - Sony CCD
2 - Panasonic CCD
3 - Fuji CCD
For CDSType: 0 - Sharp CDS
1 - Hitachi CDS (HD49322)
2 - Panasonic CDS
3 - Fuji CDS
4 - Hitachi CDS (HD49323)

A. First-time Installation:
1. Create a directory in your hard disk (C:\PCAM, for instance), and
copy all the files into it.
2. Plug in your PC camera. Windows system shows "New Hardware Found".
3. Follow the Windows instructions to setup the driver. When asked
the new driver location, choose "Specify a location" and select
"driver" subdirectory under the directory you create in step 1.
4. The Windows system will use pcam2.inf to setup the new driver.
5. Run demo application (divpcam.exe) under "bin" subdirectory to see
if the new driver works.

B. Updating Driver:
1. Make sure your PC camera is plugged in.
2. Copy new driver files into a directory (C:\PCAM, for instance).
3. Click Start Menu -> Settings -> Control Panel, choose "Systems".
4. Choose Device Manager label -> Imaging Device -> PC Camera
Capture. Then click "Properties" button.
5. Choose Driver label, then click "Update Driver" button.
6. Follow the Windows instructions to setup the driver. When asked
the new driver location, choose "Specify a location" and select
"driver" subdirectory under the directory you create in step 2.
7. The Windows system will use pcam2.inf to setup the new driver.
8. Plug out your PC camera and plug in again, to reload the driver.
9. Run demo application (divpcam.exe) under "bin" subdirectory to see
if the new driver works.